Lake Arbor, MD
Bay and bow window installation in Lake Arbor
Bay window installation in Lake Arbor, MD costs most homeowners $2,000 to $4,000, according to Angi's cost guide updated in October 2026, and a bow window averages $3,900. Swapping an existing bay for one of the same size is exact window replacement, which Prince George's County lists as needing no permit. Turning a flat window into a bay means a larger opening, new framing, a roof and a seat — structural work, and a different conversation.
No obligation for the call.
Bay or bow: what the words mean
A bay is three windows. Andersen describes it as a picture window in the center flanked by double-hung or casement windows, set at 30, 45 or 90 degrees to the wall. Pella gives the same three units at 30 or 45 degrees, on a wall with at least 40 inches of space.
A bow is four or more. Andersen's minimum is four casement windows at 10 degrees to one another; Pella says four to six, on a wall with 80 inches or more. A bow curves; a bay has corners.
Either way it is several windows, which is how it should be counted on the phone. Counting your windows.
What it costs
Angi's cost guides, updated in October 2026, put a bay window at $2,000 to $4,000 for most homeowners, with an average of $2,500 and extremes of $1,000 and $8,000. A bow window averages $3,900, with a range of $1,500 to $15,000. HomeGuide's 2023 guide gives $1,800 to $2,500 for replacing an existing bay, labor and materials included, and $2,000 to $6,000 for a new one installed.
The yearly Cost vs. Value report has no bay or bow line — its only window jobs are vinyl and wood replacement — so there is no Washington-market figure to quote for this one. What window replacement costs.
Replacing a bay you already have
Pella calls a same-size swap the most straightforward option, and Prince George's County's permit table lists "exact window and/or door replacement (no structural alteration)" as needing neither a permit nor plans.
A projecting unit is still more than three windows bolted together. It has a head board above, a seat board below and, on many units, a factory cable system that hangs the bay from the framing. Ply Gem's installation instructions say plainly that the head board is not a finished roof: the small roof over the bay has to be self-supporting and weather-tight on its own.
Worth asking about:
- Whether the roof over the bay and its flashing are in the scope, or only the glass units.
- How the new unit is supported, and what in the wall the support attaches to.
- Whether the seat board and the inside trim are replaced or reused.
Turning a flat window into a bay
This is the expensive version. Pella lists what it takes: a larger opening, new framing and support, a roof and a seat. An exterior wall is load-bearing, so a wider opening needs a header sized from the building code's span tables (IRC R602.7). Angi puts enlarging the opening at about $3,000 on top of the window, and a structural engineer at about $550 where one is needed.
It is also no longer "exact replacement", so the county's no-permit line no longer describes it. Ask who pulls the permit before anything is ordered. The contractor doing the work needs a Maryland Home Improvement Commission license either way. Checking the contractor.
The energy code applies to the glass
Maryland enforces the 2021 International Energy Conservation Code, and replacement windows have to meet its limits for climate zone 4: a U-factor of 0.30 or lower and an SHGC of 0.40 or lower. A bay puts a lot of glass in one wall, so the label matters more than on a single window. ENERGY STAR for the North-Central zone, which covers Prince George's County, asks for a U-factor of 0.25. The two numbers on the label.
What to say on the phone
- Bay or bow, and how many units it has.
- Same size, or a new or wider opening.
- Which floor it is on, and what is under it outside: a shrub bed, a porch, a walkway.
- How many other windows are going in the same order.
- Roughly the year of the house.
Common questions
Does a bay count as one window or three? Three or more units go into it, and the price reflects that. Say "a three-unit bay" rather than "one window", and the count is right from the start.
Do I need a permit to replace a bay window in Prince George's County? Not for an exact replacement with no structural alteration, by the county's own table. Enlarging the opening is structural work, and the permit question has to be answered before ordering.
Can just the glass in a bay be replaced? Sometimes, when only one sealed unit has failed and the frame, seat and roof are sound. On a 1990s bay where every unit is the same age, it usually solves one third of the problem.
Is a bow more expensive than a bay? Usually, because it has more units: Angi's averages are $3,900 for a bow against $2,500 for a bay.
Have the number of windows ready. Call to check which contractors are taking work in your ZIP code.
(844) 213-1177The rest of the decision